If an extension cord is being used, check the AC power at the end of the extension cord.Make sure the GFCI (Ground Fault Circuit Interrupter) for the outlet has not tripped.Error Condition: Indicator LEDs will not illuminate.If the battery voltage does not rise above 10.5 volts in 3 hours, or if the absorption voltage does not increase to 14.4 volts (at 77F), the charger bank will shut down and will not charge.Check the fluid in the battery and add fluid if necessary.Check to make sure there are not any loads on the battery.Error Condition: RED LED & GREEN LED are flashing.Reset the charger by unplugging the AC cord.If you still have issues, contact Minn Kota Technical Support.The bank will not charge a battery below 4 volts or above 18 volts. Check connections to battery and fuses in output cord.The LEDs can indicate why the charger is not working. For more information, you can also refer to the owner's manual.The charger will automatically resume charging when the battery voltage drops below 12.6V. A flashing GREEN LED is lit to indicate the battery is in Maintenance Mode and ready to use.After 24 hours, the charger automatically turns off and a steady GREEN LED is lit to indicate the battery is in long term Maintenance Mode and ready to use. Maintenance: When the battery reaches full charge, the charger voltage is reduced.A flashing YELLOW LED indicates the battery is charging in the Absorption Mode. Absorption: The charging current tapers down while the battery voltage is held at 14.4V (at 77° F).Bulk: During this stage, the charger delivers full current until the battery reaches ~75% charge (YELLOW LED) is lit to indicate the battery is charging in the Bulk Mode.Minn Kota’s Multi-Stage Charging delivers a fast, precise charge profile by automatically controlling current and voltage without overcharging your batteries. A solid GREEN LED indicates battery is fully charged, in long term Maintenance Mode and ready to use.A flashing GREEN LED indicates battery is fully charged, in Maintenance Mode and ready to use.A flashing YELLOW LED indicates the charger is in Absorption Mode.A solid YELLOW LED indicates the charger is in Bulk charging.A solid RED LED indicates there is an issue with the battery connection.Click the button below for the Digital Battery Charger Troubleshooting Guide.ĭigital Battery Charger Troubleshooting Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |